Well I finally reached this stage.
I didn't really want to drill more holes in the body but sods law dictates that even on the best day rain is a real possibility.
So I took the plunge... Double duck hood.
Step one Research..
Visit kit shows photo's of good/bad hoods.
CRC website - www.ac427.com good stuff
here!
I decided not to use the Lift a Dot fasteners supplied by Pilgrim. The stud is quite large, and I felt they put more strain on the GRP as you remove the hood. I used Tennex.
Results of research..
- Fit hood when nice and warm [makes hood nice & supple]
- Fit hood frame.
- Loose fit over rollbar, ensure central and bar is just above rear window.
- Check rear of hood, decide on fitting positions [I wanted to minimise fittings as I don't plan to use the hood too much]
- Start at each side positioning the fixing so the hood is